BlackWing MK 2013 Manual de usuario descargar pdf (Pagina 12)

It is important to note that the 24-pin signal cable cannot be disconnected from the sensor

bar unless the sensor bar is completely removed from the magnetic bridge. Attempts to

remove the signal cable while the sensor bar is still connected to the magnetic bridge will result

in damage to the signal cable (the strain relief will get twisted and the wires will be damaged).

There is no known reason to disconnect the signal cable from the sensor, other than to replace

a damaged signal cable. In the event of a damaged signal cable, disconnect the signal cable

from the Electronics Box (refer to Section 4.1.3), lean the scanner back until the handle

assembly is resting on the floor, remove the two wing nuts located on top of the bridge that

hold the sensor bar in place (highlighted blue in illustration on previous page), and carefully pull

out the sensor bar from the underside of the bridge. The signal cable can now be safely

disconnected from the sensor bar.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 72 73

Sin comentarios

BlackWing MK 2013 Manual de usuario Pagina 12